Dynalco SWT-1000 Speed Switch/Transmitter Manuel d'utilisateur télécharger pdf (Page 11)

Operating Instructions SWT-1000 DYNALCO

SWT-1000.r2.0609 9

4. Installation

The SWT-1000 may only be installed by trained and competent personnel. An undamaged SWT-

1000, valid configuration and suitable installation are required.

The power to the SWT-1000 should be capable of being disconnected via a switch or other

emergency means.

Before switching the equipment on, the power supply voltage should be verified to be in the

permissible range.

The sensor cable screen must be connected to the terminal ‘Sh’ so as to minimize the influence of

noise. This terminal is directly connected internally to 0VS.

5. Connections

Front view SWT-1000

Sensor connections

Sh : Screen - Sensor cable

0VS : Sensor reference voltage

+V Out : Sensor Supply

Ana. : Sensor signal analog

Dig. : Sensor signal digital

Pulsed Output

+ PO : Open Collector Output

- PO : Signal reference for the Open Collector

Relay output:

NC : Normally closed

NO : Normally open

COM : Common

Analog Output:

+ AO : Current positive

- AO : Current negative

Supply:

+24V : Power (10 ... 36 V)

GND : Power reference

: Earth

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Pas de commentaire

Dynalco SWT-1000 Speed Switch/Transmitter Manuel d'utilisateur Page 11