Dynalco SC-2124M Scanner/Monitor Manuel d'utilisateur télécharger pdf (Page 7)

2.0 Installation

Installation requires a cutout as shown in section 2.1 along with four mounting holes. Once

the unit is mounted, a nearby (less than 6 feet away) location is needed for performing the

wiring to separate terminals. One method is to purchase the optional DB-to-Screw-Terminal

modules which are DIN-RAIL mounted. Also, the supplied Cold Junction Compensation

(CJC) Sensor is necessary if any thermocouples are to be used. The Dynalco ETS-202 CJC

sensor should be mounted as close as possible to the location where the thermocouple wires

are terminated.

2.1 Panel Cutout

7.50

6.25

7.85

5.30

.1875

PANEL

CUTOUT

1 2 3 4 5 6 7 8 9 10 11 12 ... 69 70

Pas de commentaire

Dynalco SC-2124M Scanner/Monitor Manuel d'utilisateur Page 7